Giraffetools.com is the go-to place for anyone looking for the best hose reels. The platform features a wide range of hose reel designs and options. The site is currently running a promotion to help clients save up to 20 dollars on the best garden hose reels. After acquiring a hose reel, you will need to understand how to set it up. Therefore, in this post, we look at how to set up a hose reel.
How to set up a hose reel
Below is a step by step guide on how to set up your hose reel;
1. Install the hose reel
The first thing you must do when setting up your hose reel is installing it. The method or technique you use to install the hose reel depends on the type, design, and brand.
For instance, you will need brackets and screws to install it on a wall for a wall-mounted hose reel. On the other hand, if you are dealing with a portable hose reel, there is no need for installation. A significant part of installing a hose reel is choosing the correct location. The reel should get placed near the area where it will be applied. The site should also be safe and near the water source or tap.
2. Get the hose
The next step after installing the hose reel is acquiring the hose that goes on it. The choice of the hose is significantly dependent on the type of hose reel you have. This is because every hose reel design usually features a capacity limit. The capacity refers to the length and width of the hose that can go on the reel. Therefore, you must use the capacity information of the hose reel to acquire the proper hose.
3. Connect the hose to the reel
The third step is connecting the two products. Before you do this, you should first stretch out the hose to soften it and reduce any bends. Doing this also makes it easier for the hose to wind correctly onto the reel. The connection part can be a little tricky. You must first take the female end connector of the hose and feed it through the guide opening found on the reel. After doing this, you must screw it onto the water coupling connection. This component is located on the drum. You will need a pair of pliers to tighten the fitting. Doing this will prevent any leaks within the connection. However, it would be wise not to overtighten it as you may end up breaking the plastic components.
4. Place the hose on the reel
After connecting the two components, the next step is winding the hose onto the reel. The hose usually goes onto the drum. This part is relatively easy. All you have to do is coil the hose back and forth across the drum. You must ensure that you do this as evenly as possible.
5. Connect the hose to the faucet
Finally, it would help if you connected the hose reel’s feeder to a water faucet. From there, you can start using your hose from the hose reel.
Conclusion
Most brands usually offer instructions on how to set up your hose reel. More often than not, the instructions are easy to follow. This means that you do not have to hire assistance or spend a lot of time on the task.
